U0635 BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

U0635 Code Symptoms :

If your vehicle failed a U0635 test and the U0635 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U0635 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing U0635

Parts or components should not be replaced with reference to only a U0635 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

How to fix U0635 code ?

• EVAP system hose leaking
• Continuous oil flow to the VCT piston chamber
• Clogged or faulty fuel injector (s)
• Fuel tank leaking

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function.

On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.